What do you need to know about Fromwork plywood during production, stored procedures, and use?
ZGREAT wood industry tells you that you should pay attention to the following aspects:
1, storage period: before not using the Fromwork plywood, please put it indoors to avoid the sun and rain; Each time the Fromwork plywood is rejected, place the wooden sides and place the corners on a flat surface. The surface of the board shall not contact with the ground, long-term storage, keep the template well ventilated, prevent the sun and rain, and check regularly, it is best to cover the tarpaulin.
2. Use period:
(1. Sawing edge) When using building formwork plywood, especially when sawing is needed, please choose an alloy saw blade with a diameter of 300 mm and 80-100 teeth, equipped with a secondary motor, preferably with sawing machine guide rail; Try to keep the saw blade straight and rotate at 4000 RPM. If you need irregular geometry, you can use a high-speed portable chainsaw to cut the circuit board. For anti-burr, sawing, and drilling, place the board under the board.
(2. Edge sealing) In the production of ZGREAT factory, the new cutting board or drilling has been sealed, please use waterproof phenolic series paint brush saw or drilling three times, remember! If scratches, abrasions or other minor damage are found on the surface of the formwork, phenolic paint should be applied.
(3. Paving) When laying, create a template in the slats to reduce the level between the plates and the plates. Wood size is preferably 5 x 10 or 10 x 10cm. The joints are pressed flat with putty or sealed with dry tape to prevent the slurry and stock from contaminating the edges. It is strictly prohibited to collide with hard objects or crowbars, throw it on the board and drag it arbitrarily.